FOUR Geckodrive G-203V ONE YEAR FACTORY WARRANTY steppr motor Drivers W/EXTRAS

Description

These Come with a ONE YEAR Factory ONLY Warranty  if you receive a defective Gecko Drive (which is VERY rare)  You need to log onto Geckodrive.com and fill out their RMA form, then send the drive to them for replacement or repair allow a few days, after they have checked the Driver, for return of repaired or replaced product.  By Purchasing these Drivers you agree to the above
You are buying FOUR BRAND NEW fresh from the factory and newly released GECKODRIVE G-203V single axis stepper motor driver The NEW BULLET PROOF Driver from Geckodrive. This listing purchase includes extras that you do not get from the factory read on. I recently decided to become a Gecko distributor, and decided to offer EXTRAS with your purchase from me that you do not get from the factory.  With this purchase you will receive a FREE complete set (sells .99 in my store) of the needed 1/4 watt amp control resistors, to set the amp output of the driver to match your motor's needs.  The Twelve pack resistor set includes the resistors that will allow you to set the G-203V to any of the following Amp outputs for your motor.  1.0 amps, 1.5 amps, 2.0 amps, 2.5 amps, 3.0 amps, 3.5 amps, 4.0 amps, 4.5 amps, 5.0 amps, 5.5 amps, 6.0 amps, 6.5 amps and 7.0 amps per phase.  I also offer a very low comparative shipping and handling price of .99 USA.  This item comes with One Year factory warrantee. All returns must go to Geckodrive accompanied by their return data sheet.   Add it up, and it makes sense to buy this from me. Save on a lot of two, or 3 lot or 4 lot in other listings in my store.  thanks Brent
You also receive a manual on CD
Drive Specks:
7A 80VDC maximum power ratings
10 microstep fixed resolution
Mid-band resonance damping
Short-circuit protection
Reversed-polarity protection
Over-temperature protection
Over-voltage protection
Optoisolated STEP, DIRECTION and DISABLE inputs
Optoisolated COMMON is ground
2.5V, 3.3V and 5V logic compatible inputs
Recirculate mode while motor is stopped
350 kHz maximum Step pulse frequency
Top settable adjust trimpot
Power and error LED indicators
No user settable jumpers inside
morphs to full step at higher speeds to maximize motor torque
internal socketed fuse
Power-on reset
20 kHz switching frequency
Same size and terminal pin-out as the G201
Important note about SHIPPING:
·
ON
Multiple item orders only,
NOT on single item orders
,
SHIPPING COST totals can become UNREASONABLY HIGH due to the necessity for Ebay to add up all of the individual shipping costs for an estimated “not to exceed” total ship cost.
A high ship cost total on your order will be corrected by us, but only if you place your multiple order and WAIT to PAY,  UNTIL after we send you an invoice with COMBINED shipping.
Don’t use a cart
to order your multiples because it forces you to pay immediately on checkout, and, we can’t then invoice you for combined shipping on your order once you have paid.
Thanks for reading and be sure to Google Hubbard CNC to see our glowing reviews and other spectacular deals we have online!
THE MESSAGE ABOVE ONLY APPLIES TO PEOPLE ORDERING MORE THAN ONE TYPE OF ITEM FROM OUR STORE!
ALSO:
·
PROBLEMS with the Shipment -- Communicate with us ONLY BY
EBAY MESSAGE.
DO NOT communicate with the paypal email
beginning alice.hubbard, this is an order Depository email only, we do not monitor it.